wolf 3d to 1jz-gte

**1jzracing** · 26-02-2006, 11:46 PM

well you learn something every day!!!

how do you do that?

run both triggers in parrallel or in series?
and then use duel puls function on the wolf to start the sequence count ??

must play havock if you got adjustable cam gears!

**chris davey** · 27-02-2006, 08:40 AM

1jzracing: thanks for coming to the party

Well to update I have got some ignition now but it still isn't starting. I bought some crappy leads that I am going to hack up tonight so I can use my timing light and see what is going on.

I also have to try using the other cam sensor.

To set it up sync and reg I have ne- and g(x)- joining together at pin 27, then I have ne at pin 28 and g(x) at pin 6. I just put all the values in given to me by a guy running a v4+ on a 1jz and it now gets spark. I think I could have the wrong cam sensor though which AFAIK will put my timing out 180* and that could be why it isn't starting so that is the first point of call.

At the moment I have the igniter wired for waste spark.
igt1 to igt 1&6
igt2 to igt 2&5
igt3 to igt3&4

These are all on the ecu end of the igniter so no outputs from the igniter have been changed. So the wolf will now send the signal to igt 1&6 say which will then go out to cyl's 1&6 at the same time. (I hope

)

So if I can't get it started tonight then I will be back for some more help

I would be very interested to know how you have wired yours up though just to check that I have done it right. And also a look at a finished ignition map would be great

I have the wolf base map in at the moment and it looks very "base"

Thanks all

**chris davey** · 27-02-2006, 10:29 PM

ok, just been testing.

What I found was that I am only getting spark on cyl's 2&5.

I checked the diagnostic LED's and the red light for the input trigger
is not coming on.

I have ne- and gx- on 27, ne on 28 and gx on 6. I tried both cam
sensors too, no difference.

I used my map and the wolf base map and also no difference so it
shouldn't be the settings. I tried to use the map that you gave me
but it just comes up as the wolf base map?

Any ideas? I think I might have to ring wolf tomorrow.

oh and the ignition LED's are all flashing normally.