Collecting info for w58 conversion

[ditn]

IM trying to find all the info i need to do this conversion in my ae86.
All i can't find are bits and pieces every time so thats why i would like to make this thread so im sure i havent forgotten everything.

So far i have
=>my old T50
=>W58gearbox from a supra mkIII
=>driveshaft from the ae86 and from the supra
=>niteparts bellhousing incoming

This is what i found on the internet so far
needed:
W58 gearbox check
custom bellhousing check
clutch with different splines for the w58
tailshaft
gearbox crossmember
slave master

the clutch i will buy from illegal garage
for the tailshaft can i use the front part of the supra with the back part from the ae86?
gearbox crossmember
custom,mount can be used from an auto ae71?
the rest i can use from either the t50 or w58

will the position fit in ae86 i think i have position 3 from this printscreen
Toyota_Supra_5spd_Shifter.jpg

anyone who can help me with this?

[ballpencil]

just did this the harder and cheaper way by fabbing an adapter for the T50 bell like assassin1000.

- clutch with different splines for the w58

I use our local KF40 van's clutch disc. It's a commercial vehicle with 4K engine and G5x gearbox. G5x gearbox has same spline as W58 and 200mm clutch diameter. P.N 31250-YD010.
Have you any K engine Toyota Van there? Lite ace? perhaps it has the correct size clutch. you then avoid having to use custom clutch.
If you need 212mm one, i believe 1G-E cressida has the correct size. I don't know if you can find it in Australia though.

for the tailshaft can i use the front part of the supra with the back part from the ae86?

yes.. the W58 yoke should match your back part ae86 tail shaft.

custom,mount can be used from an auto ae71?

i use the stock W58 x-member with some spacers and the holes redrilled to match.

a bit more info here.. http://charmant4age.blogspot.com/201...rsion-pt2.html