2JZ injector install ID1000?

[ecko]

We've purchased ID1000 top feed for our 2JZGTE, but have a problem
The oring that is meant to fit into the stock plenum injector port is too small..
Has anyone come across this before? they are a 14 mm OD oring whereas stock are 20mm OD the whole it needs to fits is 15mm
Cant seem to find any adapters.. How are people selling these as direct fit?

[JP]

the JZ direct fit kits have modified pintles to accept a Denso injector lower seat, I think they'd only fit nicely on a vvti 1JZ though... When I did my car I used the 14mm lower o-rings and machined up some press-fit bungs for the lower JZ plenum to accept the 14mm injector. Those were pressed in with a smear of toyota black FIPG.

Not the best pic but you can just make them out here:

[pandaah]

You get the adapters when you buy the top feed fuel rail usually

[JP]

the adapters that came with my topfeed rail were pretty ordinary, which was another reason for making new ones.

[87lux]

i had to do the same as JP with my bmi fuel rail. They didn't even come with adaptors in the first place. I brought it to bmi's attention and their reply was the injectors they use seat on the factory toyota.