Installing HKS EVC1 to 3sgte - Not working?

[da_foles]

Have installed the controller - of course it doesn't work. Powers on and everything. Everything is connected correctly. There is a wire harness on the back with a plug on it. I don't think it needs to be used it says something about use it for a graphical display.
there are wires left over on the controller end and on the solenoid end? Anyone know of a wiring diagram for the HKS evc 1?
From the manual it looks like there should just be two plugs one on the controller end the other on the solendoid end. Plug those in together and it should be sweet. But the one I have has been cut and made into individual wires? There are some wires left over etc.




It came with two wiring harness, I think for a twin turbo setup. This pic is exactly what arrived.

http://www.hksusa.com/info/download.asp?id=1739

manual, pretty crap though

[jonathan yee]

looks all fairly simple? the extension loom connects the solenoid to the control unit and the separate red an back wires coming of the solenoid are for power and earth.

[da_foles]

Yeah got it working. All good. It was simple. It is only running 1.5 pound more boost over factory using manual control at max. I think i need to adjust the low and high modes and the manual control must up the boost a bit off those.