1GGTE head bolt options

[Blair]

Price?

10 char

[Kedderz]

Theres some on rhdjapan, kameari branded, around $310.
Thickness is specfied at .8mm - 3.0mm, they are a bead type gasket and suit a bore from 76mm-79mm.

If theres interest ill check with jesse streeter to see if he can get a direct buy from manufacturer and deal through him, hes much cheaper/cleaner to deal with.

[SillyCarS]

when ur buyin any new shit keddz give me a yell

need to have a beer with you to pick your brains about 1geegees

[DJ-28]

Hey Kedderz,

I'd be keen on a good quality MHG but at $310 i couldn't justify it on my current appliaction. Let me know if Jesse can get a bulk lot a little cheaper and i'll gladly chip in for one

[Kedderz]

Dont know much about horses tbh......

$310 is the righthandjapan price, so im sure it can go down alot, ill send an email and wait and see.

[81hilux09]

hay just a question, when installing the head studs to the cams have to be removed?

[Kedderz]

When I did the 7m one i didn't have to but make sure you put the washers in the head before you lower it onto the studs.

[81hilux09]

so got the head studs, installed them yesterday..we had to take the cams out which wasn't a problem. but following the instructions of the arp bolt saying to hand tighten them in. but when we put the washers and bolts on once we tightened them up the thread of the stud didn't fully come through the bolt.. they torqued up fine. should i be worried about this?

[Kedderz]

you got the 2JZ main studs right? not the head studs?

[81hilux09]

use 2jz ARP main studs for both mains and head bolts part number ARP # 203-5405

same as these, as you said

[Kedderz]

I'll let you know when I fit mine lol

[81hilux09]

great ... i'll probably tell u when the engine goes boom the first time i start it

[Blair]

let me know when that happens also

[81hilux09]

you guys are leaving me with great confidence....

[CELICASUPRA7M]

so the stud doesnt stick out past the nut?

no one would design them to be like that imo.