Help needed for 2JZ stock fuel rail adapter

**Hengsta** · 19-10-2010, 03:16 PM

Howdy lads, I need some help (pictures) with the adapter plate for the stock 2jzgte fuel rail to use for a fuel pressure regulator.

Any pics and info would be greatly appreciated

Reason I ask is there's not much room there when the throttle is all the way down.

Thanks, Heng

**midnight_purple_GA70** · 19-10-2010, 03:36 PM

just had one of these put on the missus car...

will see if i can get some pics tonight if i remember

**Hengsta** · 20-10-2010, 08:47 PM

Anyone?

Wilbo?

**midnight_purple_GA70** · 21-10-2010, 04:15 PM

grabbed some pics last night... will upload when i get a chance

**midnight_purple_GA70** · 21-10-2010, 04:39 PM

ok so not the greatest pics but you will probably get the idea from it...

some sort of fancy annodised fitting with a 90* brass barb fitting to pipe... reasonably tight but not fouling on anything...

hopefully of some use for u

**wilbo666** · 21-10-2010, 07:20 PM

I drilled and tapped mine to M12 x 1.25 (The hole is 11mm if I recall), which worked well...

On my first setup I used a Banjo bolt and and associated fitting recycled from a different OEM fuel system to the FPR (I'd happily do this again)

Playing with the fuel system later I've ended up with a 90deg speedflow -> pushloc fitting, but the clearance is pretty tight...

Cheers
Wilbo

**Hengsta** · 21-10-2010, 08:46 PM

Cheers lads,

I thought about that brass one but I didn't know when the thread will stop as I wanted it at a certain angle point but I see yours is pointing to the front of the engine (I can deal when the extra lenth of hose) buy I wanted it angled to the back of the engine.

Banjo bolt is the other one I only thought about today I'm gonna go tomorrow and see if I can get banjo at pirtek or enzed.

Cheers guys much appreciates