Results 1 to 12 of 12

Thread: 1jzgte issue

  1. #1
    Junior Member Backyard Mechanic HIZOKU's Avatar
    Join Date
    May 2006
    Location
    Victoria
    Posts
    276

    Default 1jzgte issue

    Alright im trying to think of the best way to say this

    At full load (foot flat to the floor) in 4th and 5th at about 4000rpms - 5000rpms my car hits a wall as such seems like all power just stops for a bit but if i get off the accell and go back on easy the car will go past this no problems

    So anyone have any ideas?

    Car is a 1jzgte manual with gt3037 turbo and autronic ECU
    [Gentlemen's Club]

  2. #2
    Junior Member Domestic Engineer 1jz68u's Avatar
    Join Date
    Feb 2006
    Location
    NSW
    Posts
    753

    Default Re: 1jzgte issue

    does it misfire? Are you stilll running stock coil packs?
    Glenn
    Current Ride http://www.toymods.net/forums/showthread.php?t=41123
    Previous 3SGTE ST162, 1JZ Cressida 215RWKW-ET 13.318, Celsior, XT forester, 3SGE KE70.
    Quote Originally Posted by NME308 View Post
    You do of course realize forgiveness is easier to gain than permission right???
    Cheers, Jason

  3. #3
    Junior Member Backyard Mechanic HIZOKU's Avatar
    Join Date
    May 2006
    Location
    Victoria
    Posts
    276

    Default Re: 1jzgte issue

    Does not misfire and running LS1 coilpacks
    [Gentlemen's Club]

  4. #4
    Corona loving Grease Monkey TTMX83's Avatar
    Join Date
    Nov 2005
    Location
    Victoria
    Posts
    159

    Default Re: 1jzgte issue

    Why not drive it over to me and I'll have a look and you can look at the poo car??

    Cheers Brad.
    2010 KDJ150 Prado

  5. #5
    Junior Member Backyard Mechanic HIZOKU's Avatar
    Join Date
    May 2006
    Location
    Victoria
    Posts
    276

    Default Re: 1jzgte issue

    I will when i have some time

    dont worry i have not forgoten about you LOL and car is dirty as today after winton and it hard to find out issue as it only happens at full load in 4th and 5th dont always get to do that and it does not happen with foot is slamed to the floor
    [Gentlemen's Club]

  6. #6
    dont work in my backyard Domestic Engineer pandaah's Avatar
    Join Date
    Aug 2009
    Location
    WA
    Posts
    648

    Default Re: 1jzgte issue

    you still running an airflow meter?

  7. #7
    Junior Member Automotive Encyclopaedia JZA70R_92's Avatar
    Join Date
    May 2008
    Location
    WA
    Posts
    821

    Default Re: 1jzgte issue

    1JZGTE uses map sensor not airflow meter I had similar issue ended up being cracked coil packs after some epoxy its all good now!
    1992 - JZA70 STOCK - SOLD

  8. #8
    Junior Member Backyard Mechanic HIZOKU's Avatar
    Join Date
    May 2006
    Location
    Victoria
    Posts
    276

    Default Re: 1jzgte issue

    Alright well i will have to check out the coilpacks then lets hope it is them

    lucky im running LS1 coilpacks and they are easy to find
    [Gentlemen's Club]

  9. #9
    Junior Member Backyard Mechanic HIZOKU's Avatar
    Join Date
    May 2006
    Location
    Victoria
    Posts
    276

    Default Re: 1jzgte issue

    Alright i had a look at the coil packs they seem to be fine from what i can tell

    any recomendations on places to go to have them double checked? or other ways i can check them out?
    [Gentlemen's Club]

  10. #10
    I make people cry Chief Engine Builder Draven's Avatar
    Join Date
    Sep 2005
    Location
    NSW
    Posts
    4,281

    Default Re: 1jzgte issue

    are you getting boost spikes? If the autronic's fuel-cut is set not too far above your max boost, and your wastegate/boost controller isn't great, you might be spiking into fuel cut on full throttle.
    http://www.toymods.org.au/forums/showthread.php?t=7465
    Quote Originally Posted by xero View Post
    and of course campbell newman's completely fucking everything he touches so badly that he should be called dick fingers.

  11. #11
    Junior Member Backyard Mechanic HIZOKU's Avatar
    Join Date
    May 2006
    Location
    Victoria
    Posts
    276

    Default Re: 1jzgte issue

    Alright i will look into that im using a greddy dual boost controler untill i can get a autronic one so it is all run via the ECU but i will look into this
    [Gentlemen's Club]

  12. #12
    Junior Member Backyard Mechanic HIZOKU's Avatar
    Join Date
    May 2006
    Location
    Victoria
    Posts
    276

    Default Re: 1jzgte issue

    Well i went to data log on sunday and give it a test run and could not get the issue to happen again so im guessing maybe it was a boost spike issue and not a coil pack issues as it should of happen again

    now it was alot cooler sunday but yeah took it for a nice 3 hour drive return trip and could not get it to happen
    [Gentlemen's Club]

Similar Threads

  1. 1jzgte fault code 13.......HELP!!!
    By keca18 in forum Tech and Conversions
    Replies: 3
    Last Post: 16-06-2009, 06:20 PM
  2. 1JZGTE - JZX90- Error code 12 CPS issue
    By Admiral coFF33 in forum Tech and Conversions
    Replies: 6
    Last Post: 21-12-2008, 07:59 PM
  3. 1JZGTE issue
    By fatboy13 in forum Tech and Conversions
    Replies: 27
    Last Post: 04-10-2007, 09:28 PM
  4. 1jzgte electrical issue
    By wilbo666 in forum Tech and Conversions
    Replies: 21
    Last Post: 30-04-2007, 07:18 PM
  5. boost creeping issue..
    By renxun in forum Tech and Conversions
    Replies: 20
    Last Post: 11-03-2007, 09:32 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •