intercooler fit 1ggte into ra60

[turmite]

Ummmm got the donk in.... but were do i run the intercooler plumbing, cant go thru the f/wall cause of pop up lightany ideas?

[wilbo666]

Down near the castor rods on each side there is a small plate that can be removed to run IC pipes through.

Or close to the tops of chassis rails just under the lights...

My suggestions!

Cheers
Wilbo

[turmite]

ic pipes/ sorry dude to many beers. lol but cars looking good, well as good as ra60's can
lol
What are the plate origanally for?

[Jezza_1ggtecelica]

mine run down between the front castor rod mounting points then come up to the intercooler, they dont seem to sit too low.......

Jezza

[wilbo666]

ic pipes/ sorry dude to many beers. lol but cars looking good, well as good as ra60's can
lol
What are the plate origanally for?

Haha,

IC = InterCooler

The plates are there to stop water, dirt, rocks flicking up into the engine bay at a guess...they aren't structural and are only spot welded on...

Here is where I ran my IC pipes...tis a MA61 but should give you the idea....


(through the Castor rod plate area)


(through the Castor rod plate area)


(under the light)


Cheers
Wilbo

[Norbie]

Mine go through the inner guards (used a 3" holesaw) and under the pop-up lights. This is also an MA61 but you can do the same thing with an RA60.