3TC Clutch Kit Fit A 2TG Flywheel???

**toyota81** · 24-09-2013, 02:05 AM

Would this 3TC clutch kit fit my 2TG engine/flywheel?

http://www.ebay.com/itm/AUTOCOM-Stag...8132f5&vxp=mtr

**NME308** · 24-09-2013, 08:01 AM

Hi there mate,
I believe it will fit. For best results you would want to be getting your flywheel freshly machined of course!

Cheers,
Jason

**toyota81** · 25-09-2013, 12:56 AM

Thanks Jason

**styler** · 26-09-2013, 01:09 PM

The difference between 2tg and 3tc flywheels regarding clutches is the clutch engagement area, which can be machined bigger or smaller to suit when the flywheel is resurfaced.

**brucey** · 27-09-2013, 08:51 PM

That clutch is pretty cheap, even with the postage. Might be a bit aggressive for street? I was looking for a clutch from the USA. Cheaper, but the postage is usually way over charged.

I recently tried to put a new T18 clutch to a 3TC and couldn't fit the pressure plate to the flywheel because of the different dowel pattern. Then I noticed the old clutch was smaller, i.e. 190mm instead of 200mm. Someone must of changed it to a 2tc clutch. Not sure if the 2tg flywheel has different dowel locations as well?

**toyota81** · 27-09-2013, 11:06 PM

Thanks guys.
It's a rallycar with sequential gearbox so need strong clutch.

**styler** · 13-10-2013, 01:33 PM

Yeah I was under the impression that t series dowel patterns are the same, except for 3tgteu which uses
a larger flywheel and clutch if its the w55 box and not the t50 box version. Thats what I seem to remember anyway.