4AGZE Harmonic balancer

**wogrocket** · 02-12-2012, 05:50 PM

I've currently got a 4 AGZE in my datto 1200 ute but don't need the front pully and could use the room for my thermo fans. Was just wondering if they make a aftermarket balancer without the front pulley

Cheers Mick

**trdee** · 03-12-2012, 01:21 AM

try technotoytuning. they do aftermarket pulleys for the 4A

**jondee86** · 08-12-2012, 05:59 PM

Asfarasiknose, you can part off the front pulley, and use the rear pulley on its own. The rubber insert is inside the rear pulley, so it still acts as a balancer.

Cheers... jondee86

**wogrocket** · 08-12-2012, 06:49 PM

Cheers jondee I actually did exactly what you said only a couple of days ago I'll continue to look for and aftermarket one that rubber danpned as I got I contact with technotoytuning but there's isn't rubber dampened

Mick

**rick q** · 10-12-2012, 01:28 PM

I turned the front part of the original pulley off mine [Silvertop] about 5 months ago and it's seen lots of track days since then without issue.

It's a casting, by the way, so you'd be better off with carbide lathe tools to do the job.

**wogrocket** · 10-12-2012, 02:16 PM

Cheers rick q hopefully mine will hold up too

Also what do you rev yours too ?

**SHEPPO3930** · 10-12-2012, 03:39 PM

plenty of people run cut down crank pulleys on their 4age's

**lexsmaz** · 11-12-2012, 12:13 AM

Do they run a proper harmonic balancer on the 4agze motors, years ago most 4cyl motors of different manufacturers didnt run a dampened pulley due to the short length of the cranks, etc they didnt seem to find it necessary ..

**rick q** · 11-12-2012, 01:30 PM

Also what do you rev yours too ?

It makes peak power at 7,700 - so I don't take it muck over that [limiter set to 7,900]

**30psi 4agte** · 14-12-2012, 08:44 PM

I also parted the front off of mine no dramas to 9500. Have been debating if i should go to a solid style pulley on the front for a while now..... alot of people seem to be using them with no issues reported that i have found.

Im looking to switch to crank angle sensor on next motor and the t3 ones are ready made and would just make thigs a bit easier. Just not sure on the whole no rubber dapen issue.....
Anyone run them..... anyone know of any issues ????????

**fixeruperer** · 14-12-2012, 10:38 PM

ive also turned down my 4age one, to run a crank angle sensor on it. no issues either.

http://rossperformanceparts.com/meta...balancers.html

i priced one up years ago for my 4age. custom with degree marks all way around it (for dialing in cams) and provisions for CAS. they came back with a price of 600$+. at the time, i thought the stock one was pretty good and been running that ever since haha.

didnt the solid 4agze crank pulleys used to always crack ?