st185 3sgte injector swap

[sainz]

i have brand new never used speed source 3sgte both gen 2 and gen 3 top feed fuel rail .bolts strait on.
to match top feed venom 3sgte 720cc injectors new as well .these plug staight in to factory harnes thee right imp.
make me a fair offer and there yours
http://s49.photobucket.com/albums/f2...8.jpg&newest=1
http://s49.photobucket.com/albums/f2...6.jpg&newest=1

[grue0038]

the st162 fuel rail is not a bolt on affair.

it can be.

[grue0038]

for that matter, so can the 5SFE:



simple brackets:

note: these brackets were designed for WRX injectors (they flow in the ~800cc/min range when you remove the caps) which are about 1cm shorter than standard denso top feeders.

for either rail, i used the original ends of the stock fuel rail, cut off and sealed to the injectors as seating cups:


the 5SFE rail is bigger ID than most aftermarket rails:

[jonathan yee]

yeh i realise the st162 rail can be fitted, but as far as i know noone make's the brackets to buy. which dumbfound's me, as they make topefeed rails for $300odd when it'd be so much easier to design bracket's to fit the st162 rail.

it's a project i've been thinking abvout(just picked up some 7mgte inj's) but have yet to make nice fitting bracket's etc.

and i dont think sandman is of the type to make his own, tho i could be wrong.

[grue0038]

i used simple 2"x2" leg 6061 angle. the steel yard even gave it to me for free because the piece was so small (but still 3ft long). 6 cuts, 6 holes later it's on the car.

it's a tiny amount of work for the $295 saved (the rail cost me $5 from the pick n pull).

[jonathan yee]

cool. and does it hold there/push down firmly so it seals well for forced ind?

should add that the gen2 3sge fuel rail's are the same as the st162, with the CSI feed in a diff spot. i've got 3 of the rail's at home, but been lazy and havent worked out how to fit, but that bracket looks simple enough, cheers.

[grue0038]

yup. when you measure for injector height, just subtract 2mm for o-ring crush. i ran the 5sfe rail for 2 years without an issue. the 3sge rail is even easier to get right.

[sandman]

cheers jonathan, u r right, i am not interested because i have just spent several thousand on her recently and my pockets arnt that deep and i dont have another drive car so i am trying to make something bolt straight in....its all useful info but im after gen 3 injectors that will fit in the rail....or supra 550s

[sandman]

what will fit in the fuel rails, i can always change the wiring harness connectors...

[mattysshop]

have you searched ebay stores for sard 800's?? or sard 550's??