2jz-ge problem please HELP!!!!!

[spagone]

hi im currently doin a aristo 2jz-ge conversion on to a mx83. all engine work has been done wired up the ecu and engine today just to find out theres some thingsnot going to smoothly with that..

ok to start motor was tested before removal from half cut worked fine now its in the mx83 it wont rev out but yet idles and starts perfect i have us many diffrent fourms to get info on how ppl have done there wiring and myn is pritty much done the same way as every one else has done but yet my temp gauge shoots straight up off the gauge as if its overheatin evan wen the motor is ston cold,

my thorts of the rev problem is there mite be a voltage breakdown with the coil/ignitor but yet im usin the stock mx83 coil/ignitor wires to supplie the power to tehe 2jz coil and ignitor so im out of ideas anyhelp would be much thanked..

thank you kindly,
anthony

[wilbo666]

Have you hooked up the check engine light and checked to see that you have no check engine codes?

Cheers
Wilbo

[spagone]

nah ive been tryin to find out how to do that i do remember readin it some were but have had not luck findin how and wat the codes are...
also yes my warning light is hooked up and goes out once car has started

regards,
anthony

[spagone]

fixed the rev problem.. had the nsw wired up wrong.. still havin troubl with the temp gauge tho..

[madmont]

[QUOTE= still havin troubl with the temp gauge tho..[/QUOTE]

Make sure you connect the yellow wire in the MX83 loom (temp gauge) to the yellow/blue wire in the Supra loom (temp sender) and make sure you earth the brown wire in the MX83 loom

[spagone]

Make sure you connect the yellow wire in the MX83 loom (temp gauge) to the yellow/blue wire in the Supra loom (temp sender) and make sure you earth the brown wire in the MX83 loom

haha yeah that wat the problem was cheers,

just neeed to sort sumin out for the air con now...