ST202 3SGE Gearbox into ST162 3SGE

[samet]

Pretty much as the title goes;

Will a Gen 3 3SGE's gearbox from an ST202 fit into a Gen 1 3SGE in an ST162?


Direct swap that is.

[samet]

Both are manual By the Way

[jonathan yee]

provided it's an s54 box i'm pretty sure it will. you'll have to get the starter motor with it also tho.

do you have pics?

[samet]

http://cgi.ebay.com/ebaymotors/JDM-3...Q5fAccessories

[Dale]

Should fit fine, and a standard clutch, flywheel and starter should be usable provided the input shaft has the same amount of splines.

Canada seems a long way to get a gearbox from though?!

[jonathan yee]

the starter is on the opposite side of the box with the later s series box. ie not under the exhuast manifold.

i think you'll also need the st202 cables, as someone i know had issue with the st184 cables not fitting the st202/4 linkages properly.

anyreason this box in particular? it's awefully expensive esp once you add shipping.

cheaper alt's are a NA mr2 box with some mod's to the linkages, or an st184 box will fit perfect and give you longer ratios and drop revs to about 2600rpm 5th@100kph

[StuC]

use a late model starter - the one not under the exhaust manifold
use the st16 gearbox mounts
use a camry (5s model) speedo drive/sender. It has both an elec plug/worm drive in one.
use standard st162 shifter cables with shifter arms from s53 box

all toyota parts can be used

[Dale]

Do you need a different flywheel if you use a gearbox side starter? I always thought you did which is why I haven't used them myself, if I don't need a different flywheel I'll swap mine over

[AndyTTR]

Yep, flywheels are different - ring gear needs to be flipped around.

[StuC]

oh yeah, forgot that ine. Gen2 flywheel. a gte one cabn be used but is a lot bigger and splined differently...use a 5s 6 bolt item or a gen2/3 3sge one