triple carb 1gge

**Shifty** · 06-01-2010, 02:55 PM

anyone know of an adapter or anything to get triple webers on a 1g?

**old_school_jap1** · 06-01-2010, 04:08 PM

read this http://www.toymods.net/forums/showthread.php?t=37145

**Shifty** · 06-01-2010, 04:19 PM

lots about itbs but couldn't spot anything on fitting triples

**Norbie** · 06-01-2010, 04:46 PM

Many ITB setups use a DCOE bolt pattern which makes it quite relevant to a triple carb setup (unless you're planning triple downdraught Webers or something else weird).

Such as this one linked in the above thread:

http://www.tweakit.net/shop/product_...roducts_id=114

**big_zop** · 06-01-2010, 05:10 PM

Even though its a 7M, there would still be some relevant info here - http://www.toymods.net/forums/showthread.php?t=52363

**allencr** · 07-01-2010, 05:51 AM

Originally Posted by Shifty

or anything to get triple webers on a 1g?

If there wasn't a triple setup, then you'll have to get 1.5 setups from a four cyl. Finding a twin that has the exact pattern or something close enough to modify. A single piece manifold with a cast in balance tube isn't necessary.

**Screamn_Sleeka** · 08-01-2010, 10:40 PM

Dont bother unless you are prepared to spend money on the rest of the engine, without cams and valve chain work its all in vain.

**andrew_mx83** · 09-01-2010, 10:24 PM

DOOO IITTTT!!!!

just make a manifold for it, i highly doubt ull find anything suitable ready to go.

mine is still a ways off, have gone in a slightly different direction in the meantime but the triples will go on hopefully in the next 12 months or so once the new motor is run in.