triple carb 1gge

[Shifty]

anyone know of an adapter or anything to get triple webers on a 1g?

[old_school_jap1]

read this http://www.toymods.net/forums/showthread.php?t=37145

[Shifty]

lots about itbs but couldn't spot anything on fitting triples

[Norbie]

Many ITB setups use a DCOE bolt pattern which makes it quite relevant to a triple carb setup (unless you're planning triple downdraught Webers or something else weird).

Such as this one linked in the above thread:

http://www.tweakit.net/shop/product_...roducts_id=114

[big_zop]

Even though its a 7M, there would still be some relevant info here - http://www.toymods.net/forums/showthread.php?t=52363

[allencr]

or anything to get triple webers on a 1g?

If there wasn't a triple setup, then you'll have to get 1.5 setups from a four cyl. Finding a twin that has the exact pattern or something close enough to modify. A single piece manifold with a cast in balance tube isn't necessary.

[Screamn_Sleeka]

Dont bother unless you are prepared to spend money on the rest of the engine, without cams and valve chain work its all in vain.

[andrew_mx83]

DOOO IITTTT!!!!


just make a manifold for it, i highly doubt ull find anything suitable ready to go.

mine is still a ways off, have gone in a slightly different direction in the meantime but the triples will go on hopefully in the next 12 months or so once the new motor is run in.