Hello to all. Im new to toymods. Busy droping a 1 jz vvt motor in my 2004 hilux and sitting with a speed sensor problem. Got my hands on a jzx 100 chaser half cut and the speedo ran from the abs on the car and the hilux has no abs. Only got the one speed sensor on the box which gives the ecu info on gearbox speed. The only other input on the ecu is SPD which then confirms the speed from the speedometer. I dont want to split the pulse from only the one pick up because it might weaken the signal to the ecu and could have problems when the ecu is trying to read that pulse for gear change and so on. Looking to use the cluster that came out the chaser and its a fit with a bit of a mod to the inside of the dash but im not sure on what pulse the speedo was getting from the abs. It ran from a inductive sensor on the wheels and then it runs thru its body ecu (multiplex) which then could have converted it into a square wave pulse and then to speedo. Also not sure on its pulse rate, will have to open the unit and take a look. Was thinking of doing a pick up on the prop shaft but not so keen on having magnets stuck on and they start falling off after sometime. Was looking at the Gps unit and the only thing that i dont like is that it could take time to pick up a SAT and then you dont have a read out and if the processor is to slow than you going to get a whole jumping story going on. Have you guys been here before ? Any of you using the Gps unit ? Thanks