mx83 cressida - vvti 1j swap

[KAMAKAZ]

thanks very much mate

[KAMAKAZ]

is everyone just using stock front dump pipes or is there something availiable for jzx100, will the front dump of the chaser fir the mx83, i mean wont hang to low or hit firewall?

cheers

[Wildsupra]

dude send it to the bling garage they will have the conversion done in no time
hehe jk's

Look forward to seeing the end result bro.

Matty

[KAMAKAZ]

ha ha this will chop anything the bling garage has produced ha ha just might take a while getting used to the toyota scene ha ha all good should make a sweet daily just dont want to have to many problems

Ben

[PeteH]

is everyone just using stock front dump pipes or is there something availiable for jzx100, will the front dump of the chaser fir the mx83, i mean wont hang to low or hit firewall?

cheers

Hi,

I just used the stock pipe and made an exhaust to suit that. Nothing fancy, it's just a 3" mandrel bend cut down and angled to clear the steering joint.

Pete

[KAMAKAZ]

do you think if i bought a jzx100 front dump it would be fine and then get an exhaust made up to join up to that?

do i have to remove the dash ect and replace that loom also or just the ecu loom, are they 1 piece or 2 seperate ones

(only done nissan conversions before and its really simple compared to toyota swaps it seems)

[PeteH]

Hi,

Not sure on the dump mate. Having a quick look at the one out of Joeys JZX100, the picture is here - http://www.toymods.net/forums/showpo...0&postcount=22, I'd say it would go close to fitting. At worst the lower half would need to be rotated around to bring it up under the body. If you could get hold of a cheap dump it may be worthwhile, otherwise you’d probably be best to have the place doing the exhaust knock you up a dump from scratch.

On the wiring front you only have to integrate the engine loom and ECU into the existing MX83 body loom. No need to pull the dash and replace all of the wiring.

Pete

[KAMAKAZ]

sweet well all set to get started now, siezed 7m almost out

[WA_TRD_83]

Ben... start a members ride thread so we can keep an eye on the engine swap progress

Damo

[KAMAKAZ]

man that means i have to take heaps of photos n shit ha ha both motors are out n sitting on the floor, guess i can start from there will throw one up

[WA_TRD_83]

Toymodders love PICS

you must post pics to be accepted by the group

haha

Damo

[KAMAKAZ]

ha ha no worries man well the members ride has begun but have to wait for pics as the cars at a mates place