4ag(t)e cam timing(lobe centres)

[bigstickerperformance]

Hi,
I am hoping someone out there can help me with a couple more technical cam timing questions.I have tried searching and did learn alot about the lobe centre settings for turbo engines and also advancing/retarding the cams.
My main query is what is the lobe seperation angle for the standard 4agze cams.
Looking on Bills site I have found the timing events and the duration but no lobe centre figure.
I need this figure to set my base timing as I dont have the timing cover backing plate with the marks!
I need the base setting correct in order to set my cas on the correct tooth
I have degreed the cams in to 110 lobe centres as recommemded by "the internet" for mild cams but I dont know for sure if the cams are now in the standard postion in relation to the cas tooth
my timing events dont seem to match up to bills,but i also seemed to have more then 232 degrees duration? more like 254.Is the 232 advertised or at a certain lift.Although my figures are close enough to not be at a different lift figure?


edit: I know people say put inlet cam pin at close to 12 oclock and ext at close to 6 but without marks I could be 1 or 2 teeth out!
I have adjustible cam gears,should i put the standard ones on to setup intially,then mark the head somewhere for tdc setting?
hope that makes some sorta sense
cheers for any help
Ryan

[oldeskewltoy]

screen capture from TRD Bible - AE92 engine, so cam timing should be the same.... cam circle on far left




in case it is too small.... intake opens 8 BTDC, closes 44 ABDC Exhaust opens 47BBDC, and closes 5 ATDC

[30psi 4agte]

can you put the backing plate back on to set it up?

how come you took it off ?