1g-gte shims

[2jzhilux]

whats the standard gap between the camshaft and the shim?

on most toyotas usually intake is .20mm- .30mm
and exhaust is .30mm-.40mm

[love ke70]

thats wrong
ill get the specs
i thought i posted it the other day
must have been pm....

[love ke70]

valve clearances cold

intake - 0.15 - 0.25mm (0.0059 - 0.0098 in)

exhaust - 0.20 - 0.30mm (0.0079 - 0.0118 in)


boom

[88_Supra]

valve clearances cold

intake - 0.15 - 0.25mm (0.0059 - 0.0098 in)

exhaust - 0.20 - 0.30mm (0.0079 - 0.0118 in)


boom

thanks guys that clears that up and one more are the camshaft seals the same as 7M's?

[love ke70]

camshaft seals, i just took mine into bearing shop and they matched them up and had ones on the shelf.

90311 - 35008
90311 - 35002
90311 - 35013
90311 - 35022

were the part numbers i pulled for the cams seals for a ga70

searched the numbers, matches with 3sgte, 7mgte, 5a and 4a of sorts
and others
common part.

id just take them to the local seal and bearing supplier and he will measure and match for you.

[byteme]

90311 - 35008
that matches up to the 7m,4a,3s,2e,3e, and 1n.

should be pretty easy to find.

what were the other part numbers co-referenced to ?

[love ke70]

90311 - 35008 was for the later ga70, and
90311 - 35002 was the sub


90311 - 35013
90311 - 35022
were for the earlier ga70.

i just plugged them all in and searched the lot to see what they match. i have a feeling all 4 will be the same, just different prices...

just searched the bottom 2, they list all the motors you mentioned.

[88_Supra]

sick so they are the same as the 7m's... i can get them hell cheap from repco if they are the same

[love ke70]

i only paid 5 bucks each or something when i got mine from the bearing shop.
how much are you getting them for?

[Viper]

Is it worth buying new shims? Or just visiting the wreckers and filling your pockets with various shims from any 4a, 3s you can find?
Guess it would depend on the general condition ey....

At $1.10 though, might as well get all new ones which are the correct thickness's....

[byteme]

um...you sorta answered your own question....

[Viper]

Shhhhh

(321)

[byteme]

hahaha mong...

hows that ma61 coming along ?

[love ke70]

Is it worth buying new shims? Or just visiting the wreckers and filling your pockets with various shims from any 4a, 3s you can find?
Guess it would depend on the general condition ey....

At $1.10 though, might as well get all new ones which are the correct thickness's....

getting the shims out if the cams are in is no easy feat + they all tend to be around 2.8 - 2.9 mm from factory, and if you get your seats reground, that makes all them useless.
in the case of just replacing then it may work, pita though seeings as you can get them that cheap.

[88_Supra]

hahaha mong...

hows that ma61 coming along ?

judging by his sig id say its 22% complete....