why dosent the 1G bellhousing fit my 2tgeu

[turbo ke20]

well ive sourced up a w5x box and i went to sss automotive for the 1G bellhousing. now the problem is the only holes that bolt up are the top 2 centre ones. have i been given the wrong bellhousing or is there something im doing wrong?

ive had to remove the dowels as they didnt line up either.
do i need the plate between the box and block of the 1G to make this work?

well if worst comes to worst i know where a 3t housing is with a w series box is. But i thought that 2t, 3t and 1g are the same. i even got a 1g flywheel and clutch.

what should i do???

justin

[skiddz]

AFIAK they should be the same

i know the 1g and t series flywheel's bolt up to each other

are you sure its a 1g bellhousing or is it a 3Y?

[JustenGT8]

Yup, should be the same so sounds like you might have a S or Y series BH?

[TheToyman75]

Justin,

Looks like they have given you the wrong bellhousing. They are good guys so give them a call and I'm sure they will swap it over for you.

[CrUZida]

All W series bellhousings will have a faint letter cast into them (about 5mm high, 3mm wide) on the edge of the housing (same face as the bolt goes in).

You'll see a G, T, M, S, Y, R, etc.

[Cuzzo]

I may even have one for you mr justin you can have for nothing. Just need to check what engine its for.

[turbo ke20]

heres the comparison

2T 1G
cuzzo, if you could find out what one you have that would be tops.

looks like i gotta wait for next weekend to take it back.

thanks 4 all the help

justin

[CrUZida]

That looks very similar, but at the same time slightly different to the 1G bellhousing I had.

[crowncustom]

It looks a bit like an M bellhousing to me.It's definitely not a G series bellhousing.
Cheers Brett.

[skiddz]

mmm it appears to be not even remotely close to a 2t bellhousing.... have a chat to them im sure they will see the error and promtly fix it