1jz Belt

[YelloRolla]

I used one that fits the last gen Celica (2ZZ) on Kylie's car (her 1JZ is a VVTi, so I am not sure if it is the same).

[Adsport]

posted by [coff33] :

ok guys , im fucking stuck , ive got no aircon compressor on ive spent lots of money and time with this
the following belts DO NOT FIT:
1995
1980
1900
1875

WHAT IS THE BELT LENGTH ON YOUR CAR IF YOU HAVE NO AIRCON PLZ GO LOOK AND TELL ME ASAP PLZ PLZ PLZ !!!!

[Ribfeast]

Are you definitely sure you routed it through the correct way?



Let me know how you go.

[IRB20]

6PK1905 is what you need

Im using it on my car and its a perfect fit

Thread it the same way as the pic above, but obviously miss the a/c pump

[Adsport]

the correct belt is 6PK 1865, thanks for the replies.

[IRB20]

Adsport i pretty sure im running a 6PK1905 and its working fine.

[Adsport]

yer umm im pretty sure this one i good, coff33 cant measure a belt to save his life so i did it and made him chase the one i specified. fits well. yes i am running the belt as factory run but obviously it goes from the crank pulley straight up to PS

[Ribfeast]

FYI the 6PK1900 belt is too long, tensioner is at its limit trying to hold it tight. I purchased a 6PK1875 it fitted perfectly, tensioner marks are spot on.

Aircon removed...note how close tensioner is to power steering pump when using 6PK1900 belt.


Tensioner is out of range, note markings.


Haven't taken any pics of the 1875 fitted up, but the markings are spot on in the middle, lining up perfectly. The rattle from the tensioner pulley disappeared when I put the shorter belt on too.

[allmtr]

Chuck: you mean getting rid of a/c and p/s then. If so, that is what I have and I got rid of the centre tensioner also and the alternator is mounted like normal on a sliding bracket on the bottom passenger side of engine. So it only has to go around h. balance, water pump and alternator. Very simple

Any pics of this setup?

[Shakotan_Aaron]

Thread dig up, but is this also applicable to 2jz? As far as im aware they are all the same size pulley bar maybe crank?

Also 6kp1875 is the belt to go with??

[YelloRolla]

Don't forget that the 2JZ is 15mm taller in the deck height, so it is unlikely that the 1J belt will fit.