sc12 clutches etc..

[mic*]

Sorry reece, pic was uploading while i posted.

The 3 things you mention have nothing to do with removal of the clutch face and pulley. There is a centre nut as mentioned, and removed already it seems. Then there is a small surclip and a spacing shim/washer which is fairly hard to get at as its kinda deep within the face. With that gone the clutch face will pull off the spline. It really shouldn be siezed on there but if the nut is gone and there is def no surclip then just give it a few firm taps with a mallett... After the face comes off, there is another larger surclip retaining the pulley. Once you remove this, the pulley will slide off the mounting boss - this will be a tight fit.

The electro magnet sits behind the lot, within the pulley, and is held in place by a small pin which locates into a hole countersunk into the mounting boss (so it doesnt spin with the rest of the assembly).

[reecegze]

thank you very much mic