ma70 rotors

[Dee_Dee86]

im currently changing my rotors on ma70 brakes and cant get the rotor off is there anything special about these brakes that differs from other brakes.

thanks

[Dee_Dee86]

seriously i cant get the rotors off some1 has got to be able to help

[frk5how]

Take the caliper off. get a hammer and hit the rotor where the studs comes out not the stud but the rotor its just stuck and don't hit it to hard and get some wd40 spray it around the studs than hit it again but not to hard. spray all 5 studs with wd40 and hit it with a hammer

[wilbo666]

More info?

Front of rear?

Tried using bolts to pull them off?



This may help....
http://www.cygnusx1.net/Supra/Librar....aspx?S=BR&P=1

Cheers
Wilbo

[frk5how]

that is a good question

[Dee_Dee86]

its the front rotors i have taken the calipers off and now cant get off the rotors all bolts ect are udone they just wont budge

[jimmmayyy]

Just keep tapping them around the edges and it'll come loose.

[doobs]

From memory there are a couple of tapped holes in the rotors, you can use these to screw in some bolts which will push the rotor from the hub... if not use a mallet to tap them off...

[Dee_Dee86]

From memory there are a couple of tapped holes in the rotors, you can use these to screw in some bolts which will push the rotor from the hub... if not use a mallet to tap them off...

thank you kindley was able to get them off.

[frk5how]

how did you get am off mate???

[Dee_Dee86]

with the bolt as advised took very little time at all compared to the hours of rubber malletting it

[frk5how]

haha cool i never ever done it with a bolt always used a hammer will try it next time

[wilbo666]

Tried using bolts to pull them off?



Cheers
Wilbo

Guess I need to be more specific next time eh

Cheers
Wilbo