3Sge beams information

[nomuken1]

Hi chaps,

AM a bit lost trying to decide on a 3sge beams for a rwd application .

I have read as much as humanly possible with no real answers as yet

if i install an entire front cut into another car lets say a generic rwd car ae86 s13 etc withe the standard ecu and gearbox etc will it run?
I understand that it has that strange semi drive by wire thing where the cable opens it slightly and the rest it actuated via the electronic part

has the pedal is the original car (altezza) have a part in it like a v35 skyline? or is it all located in the ecu?

im really just wanting to install it all standard ecu etc and dont want an aftermarket ecu for this application

any insight would be appreciated

I have seen this which which i dont think will help as its more of a response thing as it allows full control with the cable not just partly

Thanks

[78Rolla]

I know about your semi drive by wire thing - but I don't think there's a special pedal in the altezza - I believe this can all be resolved with your wiring. Just make sure you get someone who knows how to wire them up properly. Apart from that you should be right. Also - if you are keeping it all stock - make sure you use the stock air box and air flow meter thats built in - a lot of altezza guys have issues with response because of this

[Sam_Q]

we have put a good guide reference here:

http://www.ae86drivingclub.com.au/fo...o-AE-KE-thread