Hi guys
I'm rebuilding my r150 transmission and I can't find
The size the pilot bearing race on the input shaft should be in the fsm
the bearing inner measures 11.99mm and the race on the input shaft is 11.85mm is this
Acceptable clearance there are some wear marks on input shaft and bearing I'll
Put up a picture soon as I can any info cheers
You should be fine. I think that the bearing is a 6002 but you will get a rattle at idle in neutral once everything is all in and together due to the new clutch disc sitting in a slightly different position to the original. More annoying than problem causing esp with a 1UZ conversion. One trick that we used to use on Skyline and also the UZ swaps in NZ was to use a sintered bronze bush in place of the spigot or pilot bearing, sometimes you had to press two different sized bushes together to get the correct size but while not an issue over there in WA it seems to hard for the average parts "Bone head" to get their head around
His. 2005 GRJ120 Prado VX
Hers. 1995 KZN130 Surf (soon to be replaced by a Rav4)
1981 LN40 Hilux Trayback ute. Now an RN40 with Surf interior
1992 Factory Widebody 2door Surf 1UZ-FE V8 Auto, now for sale
Bookmarks