FT would be the setting. But if you dead set on a setting id say 90nm would be acceptable
I had to unbolt my front crossmember and now can't find tightening torque in manual or on internet.
They are 10mm x 1.25 mm flanged bolts. Can anybody help?
FT would be the setting. But if you dead set on a setting id say 90nm would be acceptable
Hi Tweak. I thought FT but being only 10mm did not want to break.
45Nm for 8.8
65Nm for 10.9
That's roughly what a good old zinc plated bolt should be done up to.
FT is just as good provided you have a good idea when to stop trying to tighten it lol
Most rattle guns with go to 90nm. Working as a mechanic its more the noise that you listen to when doing things like this up. The noise it makes when it wont/should not go any further is very noticeable
Bookmarks