loom and ecu are different bud... simple answer... nope
Is it possible to run the wiring loom and ecu from a 5me on a 5mge, I spun a bearing in my 5me and have been offered a resonably cheap 5mge without the ecu etc, I have no idea about these engine but Im guession esentially they share the same sensors and injector setup?
cheers Josh
loom and ecu are different bud... simple answer... nope
If in doubt, drift her out! Steer from the rear! less traction,more action! simple!
░░▒▒▒▓████
BURN RUBBER
░░▒▒▒▓████ JZA61 FTW!
Its been done many times using the 5ME EFI on a GE , main thing is to get the 5M dizzy turned down to fit into the GE head , $200 from a engineering shop .
Dave
If its an EARLY 5MGE, then the wiring will be plug and play with the 5ME.
If its a late one, then its all completely different.
Early ones will have a square TPS, vacuum advance dizzy, no knock sensors, and twin V belts for the alternator.
Peewee
1985 MZ12 Soarer - 1UZ Powered
2013 86 GTS
ok thanks very much for your help, I just had no idea about them really,
alright well i pulled my engine out over the weekend and have started stripping it down, Will be slipping a new set of bearings, rings and gaskets in it, With the plenum theres a fuck load of vacum hoses and setups that im really not sure about, I know the simple idle control and vacum for the fuel pressure reg but is there any need for me to leave all this, In other words can i block off all the crap? Also why on the 5me does a fuel line go from the fuel rail to the to top of the plenum (which isnt the feed or return line from the tank) it makes no sense to me nor does the reason for all this emmisions/vacum hose rig up
ah i see makes sense, ive just not seen anything like it before as im used to playing with nissan crap
im still in need of info about the vacum lines though if anyone could help, im just worried i'll put it all back together and it wont run properly if i block it all off, ive done it with 4kc's but carby and efi totally different
see this thread
http://www.toymods.org.au/forums/showthread.php?t=32147
Jealousy is a curse
thanks very much, after discussing it with my mechanic alot of the vacum system will be f'd off as well as the throttle body water lines, not thats its a performance engine nor meant to look good i cant stand a cluttered engine bay
hi all i'm in the middle of going a mx73 5mge in my supra that had the 5me just woundering how diffrent is the loams as from the guide i found on here dont say much about it
If the 5MGE is from the Aussie delivered MX73, then yes the looms are different.
If the 5MGE is from an import (Soarer, Crown, etc) then there is a chance that the looms will be the same.
Peewee
1985 MZ12 Soarer - 1UZ Powered
2013 86 GTS
right so i need to change the whole loam then i take it as it's a aussie 5mge
oh and the 5mge was auto so will that still work with it changed to a 5 speed?
Bookmarks