the gen3 3sgte are. they're 550cc and i think some of the 2jzgte's also had these injectors.
otherwise SARD make 800cc ones
what injectors are a straight swap upgrade for st185 sidefeed low impendence injectors?
the gen3 3sgte are. they're 550cc and i think some of the 2jzgte's also had these injectors.
otherwise SARD make 800cc ones
what capaciity are the oem ones for the gen 2?
430gen2
....and the gen3's are 540 my mistake
what power rating or A/F ratio would you use the gen 3 injectors too? group A 205's run 17.5psi fuel cut dont they? so must be higher?
are gen 3 high impendence? if so dont i need a resistor?
gen3 are low impedence the same as gen2 and yes you need resistors
im after a straight swap no extras just tuning...i will buy a wolfkatz fuel rail to suit 3sgte
as said the gen2 and gen3 are both low imp and both require resistor packs if your running stock ecu, if you've got gen2 low imp inj's running atm then te gen3's will swap straight over so will the SARD 800 low imp just need a retune.
are you getting a topfeed wolfkatz rail or just a bored out rail? road and track do the ored out rail's as well. they might be cheaper,
ive got sidefeed 440cc i think...(japimp gen2)i am running emanage blue and through looking at websites i thought gen 3 were high impendence. i was after the cheapest way to get fuel rail and injectors. i was thinking bored out sidefeed rail with us 2jzgte 550cc, but thats looking at about $750.
Have you considered changing to the ST162 side feed manifold, then using its fuel rail and new top feed injectors?
Youll have more injectors to choose from then.
Daily: Toyota '05 Rav4 Sport
Projects: Celica GT4 ST185 (5S-GTE), Celica RA28 Celica (1UZ-FE)
Previous: Corona RT104, Starlet GT Turbo
Classic Celica Club of South Australia
the st162 fuel rail is not a bolt on affair.
the gen3 are low imp same as gen2 any one that tells you otherwise doesn't know what he's talking about
so cheapest way is send your fuel rail as an exchange to road and track (i think they're just over $110) for a bored out rail and find some gen3 inj's should be able to pick up a set for sub $200(for 4)
cheers thats the way to go... where is road and track? whats there number?
they're forum supporter's/vendor's on the ozcelica and mr2australia forum's, he's also on here. his user name is terryo(not a vendor tho).
http://www.roadandtrack.net.au/
cheers mate i will call him tomoz....
Bookmarks