R154 rear mount vs ms75 crown

[mr75]

Hi guys

Just need to know if firstly anyone has put a r154 into a ms75 crown and if you have what did you need to make it work, as i dont have the factory r154 mount as it didnt come with my box.

Do I need this mount? If so does anyone have one? And what other toyotas came out with the R154 type mount that i might be able to use?

Any help would be awesome.

Thanks!!

[CrUZida]

If you are talking about the rubber mount then I'm pretty sure its the same as any other Toyota rubber mount from any large RWD tranny in the Toyota range from the 70's to the 90's

[mr75]

Yea I had a w40 in the car before and the mount from that seems a little too small but ill have a look tonight and see what i can come up with I guess. If worst comes to worst ill have to get a genuine one. Can imagine that will be too cheap

[gianttomato]

Mackays Automotive Rubber have the part you need for about $30. They have an online catalogue.

Not sure if they sell across the Tasman.

[CrUZida]

ZOMG, back from the dead!

[DrNick]

I used a W58 mount for a while too. Just need to chop out a little raised bit that fouls on the tranny - otherwise its the virtually the same.

EDIT : Probably should add, this was from a JZA80 Supra W58. I replaced eventually with a JZZ30 Soarer R154 mount but only because I got it for cheap. The other one was doing the job fine.

[mr75]

Yea R154 mount from toyota is around $100 and ex Japan guess i wont be putting the engine in anytime soon and im guessing mackays is a australian automotive shop? im in nz