yes i have build a custom bellhosing to this gerbox to fit the volvo engineOriginally Posted by lexsmaz
the engine is now tested on dyno whith the new mods 723whp @ 7700rpm @2.0bar boost
Love the sound of that motor as it Rev's out, it bring's back memories of the old Audi Quattro's sound..
Sorry for my lack of knowledge but what car's run a TK600 gearbox ? .. Did you have to custom build a Bell housing, or is there one available ..
Rob ..
Last edited by lexsmaz; 19-05-2009 at 04:21 PM.
yes i have build a custom bellhosing to this gerbox to fit the volvo engineOriginally Posted by lexsmaz
the engine is now tested on dyno whith the new mods 723whp @ 7700rpm @2.0bar boost
All I can say is very very impressive.It must be a handful to drive?
Cheers Brett.
Man thats some impressive numbers for 2.3 litres ....
I have been looking & inquiring around here about picking up a s/hand 20 valve B5234T or even a B5254T later motor & they all seem to be as rare as rocking Horse Shit .. I'm not after anywhere near the numbers you are getting i just love the exhaust note & the different Factor .. I'm curious as to how hard are they to get over there ?..
Regards ..
Rob ..
Just checking the trader, it looks like they're available, but not flooding the place. www.blocket.se is the Swedish trading post, and there are a few 2.3s
And only a couple of 2.5s
Hen
I need a working 4AGE bottom end. Pref smallport GZE, but all others considered. Also complete motors.
Drift Volvo. Was fun. 2JZ next time.
Hi Hen, Thanks for the feed back, my Swedish translation is a bit rusty these days !!!![]()
Roughly how much are some of those motors going for in Aus Dollars ..
Thanks ..
Rob ..
KE70 seems to be more and more popular here in Sweden.To bad this Rolla will be impossible to drive legal at the streets.![]()
1 MS55 - 3 TA47 - 1 MS123 - 1 YR21(SR21) - 1 RX80 - 1 ST165 - 1 JZS160
Bookmarks