3SGTE Vacuum Line (3rd Gen)

[mjf]

Hi guys,

hoping I could get some help. Have searched through a few threads and googled (a lot) without having much luck. I'm wanting to fit a boost gauge to my ST215, but I can't seem to find a vacuum diagram for the 3rd Gen 3SGTE. As such, I'm a little stumped as to which line I need to be splicing into.

I've taken some photos around the inlet manifold which I believe is the right area. If anybody can direct me to where the right vacuum line is that would be a great help.

Cheers,

Cheersb.jpga.jpgc.jpg

[Cuts]

That one should work.
There is a line that goes to the standard MAP sensor, or the fuel pressure reg line which both would be on the other side of the inlet manifold.

[jonathan yee]

however, make sure if you tap into the line going to the map sensor you don't damage it or have unreliable connections, becuase if the line fails your engine will promptly self destruct.

[mjf]

Hey Cuts,

When you say "That one should work", which one are you taking about?

[Cuts]

The one at the top. Just find a line that has vacuum (pull off a line with the engine running and put your finger over the hole and feel for a vac)

[mjf]

Thanks Cuts. Found the one you were talking about. Appreciate the help