just running in my new motor.

the method ive decided to go with suggests only doing about 50ks on the first oil/filter, which ive done.

it has running in oil in it now. i wasnt going to use it, but was suggested that it might be wise when using chrome rings (which wasnt by choice, but thats all i could get).

the running in oil though is a bit expensive, and also tricky to get. tomorrow i was planning to change the oil and filter. i have about 1L of running in oil left. should i use this mixed with just a basic normal mineral oil? or just run the full mineral oil?

im thinking yes (mix) as theyre both mineral oils.. so cant hurt i dont think?

the motor takes something a little under 4L. so i guess it would be about a 30/70 ratio or there abouts. the running in oil is Bursons brand, straight 30w. the other oil is just normal 20w 50.

either that.. or.. maybe leave the oil in it a while longer?

any suggestions appreciated