2jzgte kick down switch

[triptek]

I'm needing a bit of help with setting my kick down switch up properly on my 2jz z20. Just wandering if any of you aristo/2jz boys know how far behind the pedal the switch needs to be located.

Cheers
Phill

[PlacentaJuan]

i couldnt fit the stock switch under my pedal since most pedals will sit nearly on the floor under full throttle and the stock aristo switch is a chunky motherfucker.

here is how i did it from my members rides thread:

the large stock switch:



the location on the throttle body i decided to use for a switch:



the switch and bracket:



switch under full throttle, it is quite easy to adjust:



needs to be remade coz i bent it when playing aroudn with the fake rev limit and a coat of paint but otherwise works very well. the only other thing i would do is add another nut to the bit that hits the switch to make a larger contact area coz sometimes the little cutout bit in the thread hits the side of the micro switch but it still works either way.

[triptek]

Cheers for the info mate. Also do ya know which output on the ecu is the pwr button. And does it need a 12v or ground.

[PlacentaJuan]

cant remember which wire sorry, i had mos leave it out for me so i knew.

i remember it was black if that helps.

also it needs ground to switch coz i ran only 1 wire to the micro switch and earthed the other side to the throttlebody.

[PlacentaJuan]

actually its not black

its green with a yellow stripe and grey spots from the ecu