Fuel cap holder for AE101/111 Levins etc.

[TERRA Operative]

Just installed this little addition tonight.

It's a fuel cap holder that clips straight on to the fuel flap. I read about it on this site, and e-mailed the guy to get a part number.
It's part number is 77399-20010, and is used in the Australian cars listed below.

ST18#,ST20# CELICA
MCV20 LEXUS ES300
SXA1# RAV4

I assume if you have a flap similar to the first picture below, this holder should fit. (You can see the square hole and angled bit to the right of the tiger where the holder clips on).

All you have to do is cut a little bit off the top to make it fit when the flap closes and clip it on. You can see where in the picture, and when you fit it, you'll see where it needs to be cut. You only need to remove a few mm.

So get your $13, head down to Toyota and get one!

[Hiro]

Very nice, I'll have to check and see if it works for the ADM 102s. Every time I drive away from the servo I have this nagging feeling that the cap is still sitting on the boot...(I get forgetful at times, or at least doubt my memory)