need some advice with installing a manual gbox

[VasH]

Hey guys im just after some advice as this will be my first time installing a manual gearbox (W58 to 1ggte in a gz20).

Ive sussed out most of the procedure but what i wasnt sure about was if the flywheel or any other components need to be torqued down with a tention wrench or can the whole setup just be tightened up with an even amount of turns?

thanks!

[RA35GT]

You should do the flywheel bolts and the pressure plate bolts with a torque wrench. (well really you should do all bolts up with a torque wrench, but i just do the flywheel and pressure plate bolts up with one and make sure the other bolts are on tight).

Go here for step by step directions dood.

http://www.cygnusx1.net/Supra/Librar...ection=MT&P=34

http://www.cygnusx1.net/Supra/Librar...aspx?S=CL&P=10

http://www.cygnusx1.net/Supra/Librar...aspx?S=EM&P=60

[VasH]

You should do the flywheel bolts and the pressure plate bolts with a torque wrench. (well really you should do all bolts up with a torque wrench, but i just do the flywheel and pressure plate bolts up with one and make sure the other bolts are on tight).

Go here for step by step directions dood.

http://www.cygnusx1.net/Supra/Librar...ection=MT&P=34

http://www.cygnusx1.net/Supra/Librar...aspx?S=CL&P=10

http://www.cygnusx1.net/Supra/Librar...aspx?S=EM&P=60

awesome! that site is handy. + rep for you