Dyno Day 12 - Sunday January 15th 2006

[TheToyman75]

TOYMODS DYNO DAY 12!
Proudly Supported by and held at:
Silverwater Automotive Services
1/141 Silverwater Rd Silverwater NSW 2128

Cost:
Members $45 (Both 2WD & 4WD).
Non-Members $50 - 2WD, $65 - 4WD.

Thats right the 12th Bi Annual Toymods Dyno Day is scheduled for
Sunday January 15th 2006. (8.30am Start !)

Dyno Day 12 will once again be held at SAS in Silverwater. Dyno runs will be conducted in "Shootout" mode on a 4WD Dyno Dynamics Chassis Dyno. .

The day is open to members and non members alike, all vehicles are more than welcome. Remember - ANY vehicle can compete but to be eligible for the Trophies the car MUST be TOYOTA powered.

Each vehicle will receive ONE Run on the 4WD Dyno.

WE ARE STILL LOOKING FOR A SPONSOR FOR THIS EVENT! Please contact Rod Try on 0416 181 284 if your are interested in being the trophy Sponsor for Dyno Day 12!

FOOD !
The Day will start with Bacon and Egg rolls for Breakfast at $2.50 for members and $3.50 for non-members

For Lunch members will be able to buy a Sausage Sandwich for $2 and a cold can of drink for $1. Non members will be able to buy a Sausage Sandwich for $3 and a cold can of drink for $1. Rissole sandwiches will also be available at $3 for members and $4 for non members


TROPHIES.

There will be 6 primary categories with the overall Killerwatt King perpetual trophy going to the highest overall score of the day.

Vehicles will be eligible to compete in only one PRIMARY class. The vehicle owner may choose to compete in a higher class but must do so before their Dyno Run.


The 6 Primary classes are:

Under 1800cc N/A Class
1800cc - 2800cc N/A Class
Over 2800cc N/A Class

Under 1800cc Forced Induction Class
1800cc - 2400cc Forced Induction Class
Over 2400cc Forced Induction Class.


The 2 Secondary Class Trophies are:

Top 4WD
Most improved.*

* The Most improved Trophy is for the member with the Highest percentage kw increase on his/her car from the previous Dyno day. It must be the same Vehicle and must be back to back Dyno days where the entrant was a Financial member for BOTH events.

Class Trophies will be Presented at the end of the day for interstate competitors but otherwise will be presented at the following Toymods Monthly meeting, as will the Trophy for the Killerwatt King proudly sponsored by Redline Motorsport.


TROPHY ELIGIBILITY.

# Only FINANCIAL Toymods members are eligible for trophies
# Only TOYOTA powered vehicles are eligible for trophies. At a bare minimum both the block and head must be of Toyota origin.
# Toymods Membership if due or new on the day must be paid BEFORE your dyno run
# Only your FIRST Dyno Run counts towards the trophies. Should you wish to have a second run on the dyno you are more than welcome to do so. All are welcome to pay for a second run if time allows However Only the first run will be elegible for consideration. Time permitting Second Runs will be available at the end of the day.

The Offical Judging team on the day will accept comment from each vehicle owner BEFORE the car is unstrapped from the Dyno. The Judges Decision regarding any possible re-run is Final.

# The judges decision is final and no correspondence will be entered into. No arguments will be tolerated with the Dyno Operators and any inappropriate behaviour will result in the offending competitor being asked to leave.

CLASS SELECTION.

The class eligibility for your vehicle is based on the presence of forced induction be it Turbo or Supercharger and the capacity of your engine. Since there is no way to determine an engine's internal modification capacity is based on the Original Factory capacity of the block used.

There are no boost limits for the forced induction classes, the toymods car club does not handicap those people who have constructed an engine capable of supporting higher boost levels.

There are also no restrictions on the type of fuel used on the day. Should you be running anything other than PUMP gas please advise the Dyno opperator PRIOR to your run.

Should you have any further questions please feel free to contact the toymods board on [email protected]

The Toymods car Club and SAS will not be responcible for any damage, no matter how arising during testing/moving of the vehicles.

The Toymods Car Club Encourages Responsible driving to and from all of its events.

[DavGT4]

I'll be there for moral support for all the GT4's that are going to show up!
See everyone there...
Dav

[Kirsty2520]

you guys soooo need to change the monthes of these things. I won't be there. FAR to hot for little people!

[TheStitt]

I'll be there most probably trailer the 7M crown down just for shits and giggles

[BlackSupra]

Aiming to have the car registered and driveable to the event..........aaaaaah gotta love time and money

[fatboy13]

im hoping that ill be ready to come down and represent all those crowns out there... depends on the conversion though.... hmmmmmmm problems....

[Joshstix]

I'll be there to defend the pride of the AW11's.

[GBC_069]

hopefully my engine conversion should be running sweet !!! mind you nuttin spec (162)

my mate's Corrolla SX with a blacktop 20v , being dun at the moment will be there also !!!

both running, looking forward to my first dyno day !!!

nick.

[emp?]

depending on car status i will try my hardest to break 300 with the new motor

[The Witzl]

i will be there......
maybe i might even get an exhaust done prior to the day to have a crack at Pete's old record

The celica might even appear, if for nothing else but posterity.

[finney]

well my car should be there, i won't be driving it but it'll go on the rollers

[BlackSupra]

i will be there......
maybe i might even get an exhaust done prior to the day to have a crack at Pete's old record

The celica might even appear, if for nothing else but posterity.

Im going to help alchemist school you.

[river]

Hi,

Bugger, I won't be able to make, which is just as well 'cos I would of put the mighty AE71 onto the rollers and I'd need to check with el presidente to make sure the dyno equipment is strong enough to take the power.

seeyuzz
river

[Alchemist]

Im going to help alchemist school you.

Yea I'd like to be the one to stand up at the monthly meeting after the event and point out that a 6 cyl beat a V8. All depends on what Karl has done to his 1UZ though....hmmm.

Glenn I'll be calling

[smt_007]

I should be there, see what difference the extractors made.