Ok, I have finished installing the Gen 3 3SGE, it started fine no problems.
Started it a few days later after I overhauled the front end sus and brakes and now I have a code 14 error (it starts and runs for 3 secs and stops with code). Unsure of error I think its no IGF signal form igniter.
Choice's I think I have:
1. Igniter is stuffed, I think I may have dropped when tidying up wiring (used the 5SFE unit)
2. Comp is stuffed ( I hope not)
3. Maybe the 5SFE unit isn't good enough and install the igniter that came with loom.
Any hints or helpful advise??
1 thing I am only assuming that code 14 is what it is as all other codes in toyota books are the same for code 14. I do not have the book for a Gem 3 so it makes it hard.
Last edited by Aresthegod; 26-06-2008 at 09:58 PM.
Never mind I fixed it.
Bookmarks