Source for 4A --> W58 bellhousing?

[turbo4agte]

I know this topic has been covered before, but the "big thread" had a couple of dead links in it. Im also trying to find one made in the US. All of them seem to be either the Phillipines, Malaysia, Australia or New Zealand.

And my main concern is the shift fork and/or slave cylinder being on the wrong side.

I also had a question. I was always under the impression that all aluminum W5x bellhousings were compatible, but I found a website that says different: http://ourworld.compuserve.com/homep...o/engcodes.htm. They claim the W58 bellhousing is only compatible with the W58.

Im 90% likely to use a W58... so I need a housing thats made to fit that.

[turbo4agte]

Nevermind I found a guy who had one for sale that he never used.

My new question is.... Is it possible to get a 212mm 4AGE clutch resplined to the W58 input shaft?

[Cuzzo]

yes....................

[JoJo]

you can buy them at www.ajps.com.au

[turbo4agte]

yes....................

Just to make this clear:

I want to take a 4AGE 212mm clutch with stock 7/8" 21 spline hub and respline it to the W58's 1 1/8" 21 spline hub. Is this possible? Can a clutch shop do this?

[Cuzzo]

I had a 200mm clutch disc 4 puk button with t50 spline.

I got the clutch place to change it to the w55 spline. 55/57/58 are the same.

So yes.

[turbo4agte]

Thanks alot. Do you remember for how much?

[Cuzzo]

No and im sure it would be different in australia compared to US. Ring a clutch place.

[oldcorollas]

Aus shops seem to not mind doing custom work, whereas US shops have kits?
just try some decent performance oriented clutch places.. it shouldn7t be hard to do, just depends if they are willing to do it..

[turbo4agte]

Thanks alot. +Rep