I think they will *fit* but i'm not sure if they are the same flow-rate ... i could be wrong though! Sorry i can't help ya more.
Quick question.
I think my injectors in the 3sge are being dodgy. If I pull the ones out of the parts car with its 3sfe. Will I be able to get them cleaned and flow tested, then install them in the car?
Its just so I can still drive the car around while the injectors are being done.
I suspect that they will be different.
HZJ75, RS41, JZZ30
I think they will *fit* but i'm not sure if they are the same flow-rate ... i could be wrong though! Sorry i can't help ya more.
If there's one thing I know, it's never to mess with mother nature, mother in-laws and mother freaking Ukrainians
try google search ? for the flow rate, 3sge are 340 cc ? i think
Good idea.
3sge = 250CC/Min. 13.8Ohm 255KPA
3sfe = 200CC/Min 19.6Ohm 290KPA
3sfe, higher presure although lower rate of flow.. Interesting.
Taken from http://www.wolfems.com.au/support/injectorflow
HZJ75, RS41, JZZ30
Lower pressure often means that the fluid is travelling at ahigher velocity (say through a funnel) meaning that you get higher volume of fluid passing through.
If there's one thing I know, it's never to mess with mother nature, mother in-laws and mother freaking Ukrainians
Bookmarks