my thoughts exactly guys ok i will post up what i have not much time to write my thoughts:
tops of pistons
Second last power run
AFR for that run
Manifold Pressure
Power run of the run BEFORE the black line which is erratic. This shows power SPIKE to 195kw however AFR and boost curve stay relatively consistent and safe?
I have AFR for all other runs, however i have had it confirmed by a few sources that these are all SAFE and shows him just slowly getting them smoother.
Manifold pressures look the same for all runs except for the very FIRST run (that he backed out of because of timing) when it made 17 shown below? My manifold is run off an external wastegate with spring setup and no bleedvalve or boost controller just to note.
Ill post up first run manifold pressure just in case it shows something.
Havent been able to get into haltech to see what timing is set up for last run, he did tell me and was open about what he supposedly did with timing, he couldve just done an insane run to get a high reading and then changed it back, but has taken it too far?
I will get timing stuff either.
please hit me with further opinions and ffedback i really appreciate it.
rep for all when i get back from training
cheers
Bookmarks