it will spin until you bolt up your harmonic balancer and then the balancer will tighten it against your crank timing pulley
I'm re-assembling my 3SGTE and when re-installing the timing belt guide that goes over the crank timing pulley it doesnt sit on the tooth/key on the crank itself. Therefore it has nothing to stop it from spinning, is this correct? I have yet to install the timing pulley cover, does the cover(once bolted on) push against the guide and keep it from spinning?
Simple Q but I cant find the answer anywhere.
Heres the page from the Toyota BGB where it has the timing belt guide installation;
http://www.celicatech.com/imagearchi...c/EM/EM-29.jpg
Thanks!
"There is a better way to do it, find it" -Thomas Edison
it will spin until you bolt up your harmonic balancer and then the balancer will tighten it against your crank timing pulley
As said,
It doesn't locate, just gets held in place by the crank pulley
Cheer
sWilbo
Bookmarks