If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
TOYMODS FACEBOOK PAGE - For all of those out there who stalk people using Facebook, Toymods has an official Page. (well there has been one for a while, we just found it again.) LIKE Toymods Car Club to keep an eye on upcoming events.
We are starting to make some improvements to the forums, Part of this change is the Classifieds are being closed with the Toymods Facebook Group being setup with the classifieds section. Current ads can still be posted in to close out current sales, but no new posts can be made whilst we do some pruning.

Results 1 to 3 of 3

Thread: 4M exhaust valves

19-02-2007, 11:42 AM #2

Junior Member Conversion King

Re: 4M exhaust valves

Later 4M 31mm, I can measure a early one if you need me to

ST177 UZS131 Crown Royal 'G' the pimping limo like daily 1UZFE 144rwkw

DST17T MS53 68 Crown Custom Wagon 7MGTE 266rwkw

Reply With Quote

19-02-2007, 11:52 AM #3

Junior Member Grease Monkey

So later 4M will not fit then, 2M valve are 34x8x123mm.(5M-E are 33x8x113mm)

1 MS55 - 3 TA47 - 1 MS123 - 1 YR21(SR21) - 1 RX80 - 1 ST165 - 1 JZS160

Reply With Quote

Quick Navigation Tech and Conversions Top

« Previous Thread | Next Thread »