Camshaft Timing Tool

[RT104GT]

Here is the image and here is the link. Dont know how you get correct scale.

The tools is a fraction less in length than an A4 piece of paper lengthways OK
Document size was 215.9x297.2 mm
My rez was 1280x1024
It will look different depending on your computer scree settings but using the dimensions I have set out here you should be able to make up a good and accurate likeness.

Here are the dimensions of the SST.
So you can check the scale.

Outer end to end 205.65 mm
Inner to inner end 203.65mm
Inner to start of Cam key 25mm
Inner to end of cam key 29.5+mm
Camshaft key thickness 4.5+mm
End of cam key to far end inside 200.75mm
End of cam key to far end outside 201.8-mm

Inside to inside locks over camshaft.
Notch keyway locks the cam at TDC as per the handbook.

18RG Engine service Page 5-31 Figure 5-101



Removed and in this link

http://people.aapt.net.au/~sg4/img361.jpg




Sorry about the cock up.



I scanned it in full size, dont know how you figure it out but if you can you should ba able to make one from the template.

[BeRad]

some cad drawings would be handy, but doing it by eye is easy anyway.

[EVOSTi]

you can buy a similar product from tool shops for quite cheap, have one at work but never use it. easier to do it by eye and less mucking around.