2TG vs 3T-C valve angles

[Steve M]

Hi everyone,

I'm looking for the valve angles for a 3T-C.

I need:
- angle from the block surface to the inlet valve (measured to valve stem, not valve head),
- included angle (between the valve stems)

If the included angle is not symetrical around vertical, could I get the angles of intake and exhaust away from vertical and then down to the face.

The most important measurements that I'm after are those between the valves, relative the vertical.
I can work out the rest from there.

Thanks guys. (and girls)

Steve M

[o_man_ra23]

get a throwaway head from a metal bin... take it to a machine shop.... get them to chop it in the middle of where the valves operate

Thats the best way, then measure it, post on toymods, recieve rep. I dont think too many people have bothered chopping a 3TC yet, cause they are sooo poo that they arent worth worrying about.

Cheers, Owen

[WDE_BDY]

Try http://toyota3tc.com/forum/index.php...d6c312247d9977

The 3TC is very worth playing with, they are capable of 7 second 1/4 miles with massive boost.

Callum