18RG Exzaust Setup

[NZ_Corona]

Hey everybody i gotta t100 Corona coupe with a 18RG engine in it lumpy cams rebuilt and ea tractors ported and polished. my question is what type of exhaust system should i setup. At the moment its only Extractors running temp onto the stock old exhaust .

[andurils_sheath]

A 2 or 2.25" stainless mandrel bent system is ideal. With a res and mufflers to your preference. Ideally as higher flowing as possible. Be aware thought the 2.25" system will be very loud, the 2" not quite as loud but still very loud.


QUOTE=NZ_Corona]Hey everybody i gotta t100 Corona coupe with a 18RG engine in it lumpy cams rebuilt and ea tractors ported and polished. my question is what type of exhaust system should i setup. At the moment its only Extractors running temp onto the stock old exhaust .[/QUOTE]

[twentyEight]

I'm pretty sure that mine is a 2.25" system (definitly bigger than a 2", but have never measured it) and IMO sounds awesome!

It is loud, but it's not anoying and doesn't sound tinny at all...

[Norbie]

I've got a 2.5" system on mine which falls in the "stupidly loud" category. If I was doing it again I'd go with 2.25".

[The Witzl]

i have a 2" mild steel press-bent system. It works well for me, and is loud and throaty without being "stupidly" loud.

[WDE_BDY]

2.25 inch on mine, Coby resonator and cheap factory type rear muffler. Sounds pretty good on my KE70.

Callum

[maurice c]

2.25 with two Berkly straight through mufflers, flowss good without the "fully sick" sound sound you either love or hate.