3S-GE Gen III into ST184

[Aresthegod]

I am about to begin this conversion, I was wondering if anyone else has completed this conversion and any problems that were encountered. The subject engine is out of a Japanese MR2, besides the loom extension I was a bit concerned with the lower support member post installation.

Secondly anyone know of a site where I can download the toyota workshop manual for this engine and wiring diagrams I have the ECU pin locations from this site but would like to run the tests described in this manual prior to startup. I have the actual workshop manual for a Gen II but this is different to a Gen III.


Cheers

[Aresthegod]

Well this conversion had its issues, but it went fairly trouble free (few minor glitches here and there). The car goes beautifully, nice power, the wife is very happy. If any 1 is interested I will post a more descriptive post on issues and troubles I encountered, and some photo's of the final product if you wish. Very happy when compared with the 5S FE. To my surprise it started first go with no elec problems.

Cheers

[RA35GT]

Sounds good mate, get some pics up !