I know of someone, send me a PM if you like
Wasn't sure if I should put this in parts wanted or not but...
Does anyone know a place that can do small scale milling? I need some parts machined up that are less than 2" by 2" but can't seem to find anywhere/anyone that can do it. They need to be milled rather than turned because of a strangely shaped bore. This is causing major hassles for my build at this point :/
Cheers
Henry
The world's slowest TA22 Build
My no longer embarrassing DD >> The debt is worth it
+rep if i earn it
I know of someone, send me a PM if you like
Just go to any fabrication shop
GT-Four Group A Rallye, Carlos Sainz Edition # 21 out of 150.
ST215 engine conversion
Bookmarks